crankcase oil

15 examples (0.03 sec)
  • This was important as it also reduced the speed of the crankcase oil seals alongside them.
  • A viscometer was used to test the body thickness of crankcase oil.
  • The Victory engine is air-cooled, and also circulates crankcase oil through a cooler mounted between the front frame downtubes.
  • It was recognised that the crankcase oil would become contaminated with water from condensed steam and blow-by from the pistons.
  • The RW-133 was developed in 1979 as an all-new piston engine for amateur-built aircraft, including a new crankcase oil system.
  • Floor mounted reels were adapted to facilitate the dispensing of crankcase oil and were eventually incorporated into lubrication cabinets.
  • Some examples of waste oil are used oils such as hydraulic oil, transmission oil, brake fluids, motor oil, crankcase oil, gear box oil and synthetic oil.
  • The engine reaches a point where it is generating so much oil mist from its own crankcase oil that shutting off the fuel supply will not stop it, and it will run faster and faster until it is destroyed.
  • The second problem is far more significant - the upper oil pan casting incorporates the oil pump's supply passage, and is sealed to the crankcase oil filter housing with a paper gasket.
  • In addition, if excess crankcase oil is present on start up, there is a danger of the engine starting and accelerating uncontrollably to well past the speed limits of the rotating and reciprocating components.
  • Since the less volatile components of the fuel will have the greatest tendency to condense, the degree of crankcase-oil dilution is directly related to the end volatility temperatures of the mixture.
  • Head came up with the idea of placing the skis in a heavy rubber bag, pumping out the air to produce a vacuum to provide pressure, and then immersing the entire assembly in a barrel of boiling crankcase oil.
  • A crankcase heater's sole purpose is to prevent refrigerant migration and mixing with crankcase oil when the unit is off, and to prevent condensation of refrigerant in the crankcase of a compressor.
  • Some examples of types of products that after use, can be labeled as used oil are: hydraulic oil, transmission oil, brake fluids, motor oil, crankcase oil, gear box oil, synthetic oil, and grades 1, 2, 3 and 4 fuel oil.
  • For 1959 the V8's stroke was increased to, raising displacement to, This was the beginning of factory supplied performance items such as 4 bolt main bearings and windage trays to reduce friction from crankcase oil.